Dragonfire

iTrader: (1)

No problem guys I'll give it a try.

Cheers...

miku

Can someone let me know where on the speed passions website the software updates are.

Regards

Michael

miku

razzor

its listed under the top heading "apparel"

MTX

Adam.. I have just purchased speed passion brushless analysis tool. and when I wanted to run the motor checker function. the motor was connected without any load and running at full speed for few seconds during the test.

Some say that it is not recommended to put full throttle on the brushless motor and let it run for few seconds, it will damage the brushless motor.

what is your comment on this?

Thank you

abailey21

iTrader: (37)

I have never personally damaged any motors using the brushless analysis tool, and I have run some motors over 3-4 minutes at a time.

I have read and I have been taught the same message about keeping "some" sort of load on it, which I do try to whenever I use the brushless analysis, or even my vehicle.

So I would make a conscience effort to follow that rule to make sure that your ESC and motors last as long as they can.

tmunno

iTrader: (1)

Adam, Shawn Thanks for all the help you guys sent to Toni for the Reedy Race. She has been real busy getting ready for exams in A-School. 3)B+'s and 2) A's on the exam the day after returning from the race. She finished dead last in 13.5 and had a blast. Charlie B helped her finish up her esc setup and get her car ready for race. She would have typed this herself but she is a Slacker. . I'll have her try and call during the week .

s.nicholson

iTrader: (2)

I have done some testing in Onroad and i have found the 205G to be the best firmware for me that is.

Dragonfire

iTrader: (1)

Do you carry the gear to update the ESC to the track? If you come to CC and you don't mind can you do mine? I can't seem to find the motor checker to hook it all up.

Cheers.

s.nicholson

iTrader: (2)

Just use the LCD program card and connect it to the PC.

gregm

iTrader: (57)

How do I know which version of the software I am running?

Anybody seen Adam lately?

razzor

You need the lcd programmer and a pc to check, change and update the esc firmware.

MAD916

just want to say thanks to Shawn and Adam for a incredible turn around on some ESC and motors we had isses with. this is our first experience with service of product and these guys earned an A++++++


Thanks guys

TZR

tc3 racer sc

hi guys anyone got a good stock setup on ur gt pro2. esc to share ur settings running 17.5 thxs reggie

charlie_b

iTrader: (1)

What kinda car ya running? Sedan? Buggy? 4wd Buggy? Truck? Mini?