MTX 5
#421
any updates
#423
#424
N off july is official shipping to all world....ooooooo yeaaaaaaa
#425
Tech Elite
iTrader: (46)
http://www.rcbonus.com/news/?p=496
havent noticed before but by looking at this pics! the side pulleys look like directly
placed over the shafts, no more pulley adapters (perhaps less rotating mass), no rear
chasis brace due to alum bulkeads so no need for that, and the radio tray is open in the back so to go give space to the fuel tank and also providing maximum flex to the chasis, also by looking at the chasis i see two holes, perhaps that is to use screws when flex is not desired!
finally if it goes like the mrx series, i see the first upgrade the turnbuckle in the front uprights to be replaced for a longer one, stock is 22mm, in the mrx series 30mm is used, but i will say
maybe 27mm is enought, anyway lets wait and see
will keep it posted
btw just ordered RPM tires, which are now imported by mugen racing in the US, rpm tires are manufactured by matrix in italy! so now you have ennety and rpm tires to choose from!
havent noticed before but by looking at this pics! the side pulleys look like directly
placed over the shafts, no more pulley adapters (perhaps less rotating mass), no rear
chasis brace due to alum bulkeads so no need for that, and the radio tray is open in the back so to go give space to the fuel tank and also providing maximum flex to the chasis, also by looking at the chasis i see two holes, perhaps that is to use screws when flex is not desired!
finally if it goes like the mrx series, i see the first upgrade the turnbuckle in the front uprights to be replaced for a longer one, stock is 22mm, in the mrx series 30mm is used, but i will say
maybe 27mm is enought, anyway lets wait and see
will keep it posted
btw just ordered RPM tires, which are now imported by mugen racing in the US, rpm tires are manufactured by matrix in italy! so now you have ennety and rpm tires to choose from!
#427
#428
#429
#431
Tech Adept
nice looking car i do have my concerns though, we shall see
#432
#434
Tech Adept
yes this is something i was thinking about...atleast from what you can see in the CAD pics... im sure it would be something they address before release...
#435
Tech Elite
iTrader: (5)
I think another brand did try it, but then had to come up with a brace after release?, can't remember what brand it was though.
What worries me is I can't even see on the CAD pics where you would brace it, having said that maybe Mugen can make a chassis without it, first time for everything I guess.
What worries me is I can't even see on the CAD pics where you would brace it, having said that maybe Mugen can make a chassis without it, first time for everything I guess.