BMI Racing Discussions
Tech Addict
iTrader: (5)
Originally Posted by Kraig
Jason, congrats to you on the success you guys are having. Your products are some of the nicest to come through my doors.
I just have 1 question about the setups posted by Kris. If you didn't remove the shims from the lower hinge pin blocks what would happen to the car?
Thanks and congrats!
Kraig
I just have 1 question about the setups posted by Kris. If you didn't remove the shims from the lower hinge pin blocks what would happen to the car?
Thanks and congrats!
Kraig
The car will just have a little higher roll center with the shims in there. To be honest, there was so much traction available for most of the week- treating the cars like a typical rubber tire car wasnt working as well as treating them like foam tire cars. i wanted a little more on power steering because of the sweper and carousel type turns on the track, so I tried slamming them. It ended up working pretty well.... but I also had to sauce the fronts a little less to get back some stability.
I would say in 99% of situations, the first setup that I posted would work better and be easier to drive.
kris
do you think we can get some pics of the new 1/12 car as it is now?
just some updated ones
just some updated ones
Tech Elite
iTrader: (9)
Originally Posted by Kris Preisinger
will do. i'll send the xray set ups also.
Congrats Jason on the success of your drivers in both TC and 1/12. Very nice design on the 1/12 as well.
Tech Addict
iTrader: (5)
Originally Posted by dawgmeat
what hole did u use on the front bmi shock tower
3rd hole out.
Originally Posted by masta-racah
do you think we can get some pics of the new 1/12 car as it is now?
just some updated ones
just some updated ones
thanks paul.here is a couple pics of the actual production versions
Tech Champion
iTrader: (264)
Will the New CRC front end bolt on the car?
yes it will
Tech Master
When will they be available for purchase?
the first batch sold out but i am working on the next batch now.maybe in about a week or so.
Tech Master
Jason,
You've got PM
You've got PM
Originally Posted by protc3
the first batch sold out but i am working on the next batch now.maybe in about a week or so.
Hey Jason, how much for that bad boy ?
How often do you have to replace the "T" bars ?
Thanks.
Tech Addict
iTrader: (5)
Originally Posted by protc3
thanks dude.when you schreff and larry get a chance,email tim at [email protected] your guys birds setup so we can put them on the website
"The e-mail message could not be delivered because the user's mailfolder is full."
Originally Posted by jag88
Hey Jason, how much for that bad boy ?
How often do you have to replace the "T" bars ?
Thanks.
How often do you have to replace the "T" bars ?
Thanks.
they are 250.00.i am yet to break a flex plate.they are extremely strong