BMI Racing Discussions
#9018
Yo Jay...
Check this out...
Check this out...
#9021
Originally Posted by protc3
not bad for a tranny
#9024
Originally Posted by Jekyll
Do you have a status update on the asphalt chassis for the T2?
#9025
Jason,
YGPM re IB3800/GP3700 compatible chassis for TC3.
Cheers,
Scotty P.
YGPM re IB3800/GP3700 compatible chassis for TC3.
Cheers,
Scotty P.
#9027
Tech Master
Join Date: May 2005
Location: Under that rock you just kicked over!!!!
Posts: 1,040
protc3,
new t2 chassis looks the nuts...
can you do it without the carbon standoffs...as i dont use them (not an indoor racer), and just machine them flat?
new t2 chassis looks the nuts...
can you do it without the carbon standoffs...as i dont use them (not an indoor racer), and just machine them flat?
#9028
Jason
YGPM
YGPM
#9029
Jason -
I finished putting the car together last night, thanks for getting the kit to me in time for the Nats. I really like the added stiffness it offers, it should be just the ticket for the high traction carpet.
I do however miss the battery tape channel milled on the bottom, I always thought that was one of the coolest things about the BMI and IMHO would have been worth the extra cost.
Thanks again and keep up the good work, you deliver a killer product and I will be ordering from you again in the future.
http://www.deepwest.com/rasta/RC/BMI-T2.jpg
I finished putting the car together last night, thanks for getting the kit to me in time for the Nats. I really like the added stiffness it offers, it should be just the ticket for the high traction carpet.
I do however miss the battery tape channel milled on the bottom, I always thought that was one of the coolest things about the BMI and IMHO would have been worth the extra cost.
Thanks again and keep up the good work, you deliver a killer product and I will be ordering from you again in the future.
http://www.deepwest.com/rasta/RC/BMI-T2.jpg
#9030
Tech Champion
iTrader: (42)
Hey all just a heads up on Express on road championships..
http://www.rctech.net/forum/showthre...=105540&page=1
http://www.rctech.net/forum/showthre...=105540&page=1