Geppetto

iTrader: (35)

That's also identical to the one made by Niftech. The Niftech one is $25 though!!!

antoniop

But much more sophisticated!!!!

One for laydown and one for upright.

I bet that the metal is something exotic made to incredible tight tolerances

BagofSkill

aligning the brush hoods to suit the cocked brushes is the best way to do, but before you start you shuld slightly enlarge the holes (in the metal only!) that the spring posts bolt through. Learn from Big Jim , he's a legend!

http://www.rcvehicles.about.com/libr.../blackbook.htm

Kraig

iTrader: (81)

Don't align the brushes directly across from each other because of the brush shift as mentioned earlier. You really only need the bar to go into the brush hood.

ottoman

iTrader: (13)

Kraig...do you stock the bar type aligner?

Peter Busch

Dont waste your money on the Niftech one like I did. Like antoniop said, you need both. One to do laydown and one to do standup at 25 bucks a pop!!!!! The Racers edge one will do both for probably around $12.00 or so.