MurfDogg Motor Works Discussion thread
#907
Tech Adept
I am going to buy a 17.5 version of this motor when they are available again. Does anyone have any gearing advice they could offer for this motor when running it in a Kyosho sc-r or sc10?
Thanks in advance
Thanks in advance
#909
Tech Elite
iTrader: (267)
Just wanted to share a little tip with you guys I got from Matt over at the Reedy race when he was providing team support.
When soldering wires straight to the top of the motor posts like the first picture oppose to the second picture where the wires are soldered inside the post holes it is a good idea to solder in the holes carefully through to the front side to keep the posts in place to avoid movement of the posts especially in offroad where there is excess jaring but still a good idea on road.
1.
2.
When soldering wires straight to the top of the motor posts like the first picture oppose to the second picture where the wires are soldered inside the post holes it is a good idea to solder in the holes carefully through to the front side to keep the posts in place to avoid movement of the posts especially in offroad where there is excess jaring but still a good idea on road.
1.
2.
#910
Tech Elite
iTrader: (3)
MurfDogg 2s Lipo and more new items are available at TQ RC RACING.
Click Here to check out the new arrivals.
You can buy online or at the shop.
Thanks.
Click Here to check out the new arrivals.
You can buy online or at the shop.
Thanks.
#912
are all sensor boards (white) failing. i have one that i havent run yet. matt u have a pm
#913
anyone? matt u have pm
#915
Tech Champion
iTrader: (45)
I believe that the white plug sensor boards are being updated to the black ones. Some white ones have failed but not every single one of them. I believe Matt posted a few pages back that he is updating everyone that is having problems. He should be replying back to you soon.