Hitec Servos with Airtronics/Sanwa Receiver?
#1
Hitec Servos with Sanwa/Airtronics Receiver?
Sorry for taking up space on the board but I just found out that it's possible to do.
Last edited by V-One S Racer; 07-19-2003 at 06:54 PM.
#2
As long as you have a hitec servo with the universal connector, and an airtronics reciever that says it accepts 'z-connectors'. That is the airtronics word for universal connector.
If you have a hitec with a J connector, all you've got to do it trim the extra bit on the side (you'll see it if you've got it) with an
x-acto or dremel. It takes about a minute.
If you have a hitec with a J connector, all you've got to do it trim the extra bit on the side (you'll see it if you've got it) with an
x-acto or dremel. It takes about a minute.