team petit'yo "Brushless preparer"
#1
Tech Regular
Thread Starter
team ptit'yo "Brushless preparer"
1st preparer of brushless in france, and winner of the 1 st round of the championship in france and motors classes A final
THIS IS CHANGING THE MAJOR:
- Lubricating bearings HighSpeed
- Timing sensors
- Rotor timing
- Retendu-winding (about 1cm)
- Welds redone
- Cleaning integral (winding, sensors, slopes)
- Replacement of a Antiparasite
- Polishing customize number
- Plays lighten (invisble without disassembly)
- Alignment of the magnet at the point of operation
- Timing sensors
- Ventilation-made for a better flow
- Rotor small diam.
- Welds high temperatures
http://teammagice4.blogspot.com/2008...-par-team.html
For information, estimates and rates please contact us:
Http://www.teamptityo.com/
[email protected]
Last edited by nocif13; 03-27-2008 at 02:28 PM.
#3
Tech Regular
Thread Starter
We can prepare the motors to have more torque, or more speed edge and prepare for a better cooling, or on turbine motors
All defects are lifted out of the engine, and even when we repeat the windings when a complete engine cramé or in poor condition
All defects are lifted out of the engine, and even when we repeat the windings when a complete engine cramé or in poor condition
#4
staff
good morning,
I am the preparatory which made what you saw on the site and the blog.
I can accomplish preparations for look or for output, I made also by compensations as well as of optimizations, afterwards I also know how to adapt the motor to your need, potency, speed or a few two.
if you want it contacted me by email has [email protected] me you will re-lay as quickly as possible.
ptit'yo
I am the preparatory which made what you saw on the site and the blog.
I can accomplish preparations for look or for output, I made also by compensations as well as of optimizations, afterwards I also know how to adapt the motor to your need, potency, speed or a few two.
if you want it contacted me by email has [email protected] me you will re-lay as quickly as possible.
ptit'yo
#5
#6
looks like there are airvents near the join of the endbell, interesting design there...
#7
Tech Regular
Thread Starter
my motor by team ptityo 6.5 feigao
#8
So how would I get a motor modded?
Sounds pretty cool, id like to test one
Sounds pretty cool, id like to test one
#9
it is sure
hi,
I can change all motors at request, it is enough to ask me and I you will say if it is accomplishable.
thanks
Ptit'yo
I can change all motors at request, it is enough to ask me and I you will say if it is accomplishable.
thanks
Ptit'yo
#10
Tech Regular
Thread Starter
#11