acko

iTrader: (3)

i have a futaba 3pk and novak GTB. when trying to program the speedy it will set full throttle but wont recognize the full brake. is there somthing in the transmitter that i have to set to allow the brake function? has anyone ever had this problem before. i can get it set up with my 2pl.with the speedy on (not in set up mode) if you press the brake the car moves slowly foward and then when i press foward i have full foward function
any help would super
thankyou

magm20001

iTrader: (5)

u need to reset the GTB to suit your 3pk.

read the gtb instructions. thats what its there for

acko

iTrader: (3)

thats the problem. the speedy wont set full brake in the reset function. i found that out after i read the instuctions and tryed setting it, hence this thread.
but thanks for that

fathead

Make sure you have your ATL (brakes) set to 100%, I have a 3PK & a GTB and thats the only time I have had a problem is when I had the ATL down at about 30%, it wouldn't recognize the brake in the setup.

acko

iTrader: (3)

thankyou fathead. you fixed it in 1 sentence. ATL was at 0%. cranked it up to 100% and she is ready to race
i should have just PMed ya
thankyou for your knowledge

fathead

No worries