2 Used Cen Matrix FTE rollers
07-19-2007, 07:54 PM
#1
2 Great used Cen Matrix FTE rollers $499+Extras
1-White&Green has red cnc Cen steering knuckles,Gene Hickerson cross pin dif conversion and center dif has aluminum case, Eck-tec front rear upper arm holder(cnc). Rear lower Cen 3T-1S & 3T-3S CNC arm holders. Pro-line HD wing, RGX body,Cen cnc bell crank, Used Jammin wheels,rear Cen cnc shock tower.
2-The yellow flame roller was bought used as a back-up and has Kyosho difs F/C/R installed and red Cnc Cen steering knuckles.
All spare parts showm are included over $900 invested
$499.00 4-All email at [email protected]
2-The yellow flame roller was bought used as a back-up and has Kyosho difs F/C/R installed and red Cnc Cen steering knuckles.
All spare parts showm are included over $900 invested
$499.00 4-All email at [email protected]
Last edited by srad30; 08-13-2007 at 03:46 PM.
07-20-2007, 10:04 AM
#2
$$$
I might split them up as well!
LMK
LMK
07-20-2007, 10:13 AM
#3
How much for one with alot of the parts?
07-20-2007, 10:44 AM
#4
Would you part out any of the cnc parts? Also PM price for 1 as a roller. Thanks!
07-20-2007, 10:53 AM
#5
yhpm 
07-20-2007, 12:09 PM
#6
back at ya!
07-21-2007, 11:35 AM
#7
White/green Matrix sold seperately with the spare parts$ except the rear 3t-3s red arm holder shown will go with yellow flame FT-Matrix $$325
The Yellow Flame FTE with the cen 3T-3S holder included -$200
Or all together $525.00
The Yellow Flame FTE with the cen 3T-3S holder included -$200
Or all together $525.00
07-21-2007, 03:45 PM
#8
New Price!
The White/Grn was only used for no more than a gallon.
07-22-2007, 08:28 PM
#9
Dont' let the few posts scare you, this guy is as honest as they come.
Are you going to Madness for the RC Driver race on Aug. 4,5 ?
Are you going to Madness for the RC Driver race on Aug. 4,5 ?
07-23-2007, 05:40 AM
#10
Well thank you! Still glowing over that first place finish
07-23-2007, 05:38 PM
#11
$500.00 For All
07-24-2007, 04:09 AM
#12
$500.00 For all
BUMP
BUMP
07-24-2007, 10:23 AM
#13
I would be happy to take more detailed pics if needed!
07-24-2007, 09:03 PM
#14
Bump
Last edited by srad30; 07-29-2007 at 08:46 AM.
07-25-2007, 12:35 PM
#15
Bump
Last edited by srad30; 07-29-2007 at 08:46 AM.