finchy

Try Harmony models in HK. Mr Lam is very helpful and has a great array of stock.

sparksy

iTrader: (14)

Get him to ship it Via Darwin so I can have a look at it AB.....

I havent been able to find a single hobby shop up here... Lots of pubs, but no hobbies.

finchy

Hey Manticore have you had a chance to try out your Evo conversion kit yet. Do you have anything to report.

Manticore

Hi Sparksy ! i miss you !!!

finchy

not able to touch on the conversion kit yet as I need to make provision for the clutch bell on the main chassis as I am going to run with Mugen clutch.

finchy

so Manticore you have to mody the chassis. Is this due to the small nature of the fly wheel. Recently I lightened the standard fly wheel now it's as small as the Mugen one, so I may have to mod the chassis as well. Is this correct.

Manticore

finchy,

you still need to mill the engine mount to make it shorter so that the engine may sit lower and in that sense, the clutch bell will touch on the main chassis. you need to make a slot there to avoid the clutch bell touching the main chassis.

finchy

Thanks Manticore, I'm using Kawahara engine mounts with the motor, what you just said is what I've done to the standard chassis, so at least I'm doing the right thing. Thanks once again Manticore.

dtm

The carbon piece was something I made from scrap graphite...

AMGRacer

You are going without your hobby for your country and we salute you.

*salutes*

I thought you could buy ANYTHING at a pub, generally it fell of the back of a truck?

Manticore

xray vision

manti you are out of control......
Can't see the nos bottle though.....

Manticore

that's not my car !

xray vision

Do you have any specs on it at all?
Great looking bit of kit.

Manticore

i cannot read japanese but I think it is a rotatory engine on a V1R

NTC3 Kid

Far out that thing's mad