Hot Bodies Cyclone12
#61
Tech Regular
iTrader: (11)
Anyone know which servo works on this car....
I have a futaba s9602 and it's too tall. It looks like a s9650 will work, but I'm not finding a spec sheet on the net that confirms the height from the "bottom of the ears to the bottom of the case". Instructions state 19-22mm.
I have a futaba s9602 and it's too tall. It looks like a s9650 will work, but I'm not finding a spec sheet on the net that confirms the height from the "bottom of the ears to the bottom of the case". Instructions state 19-22mm.
#62
Tech Addict
Anyone know which servo works on this car....
I have a futaba s9602 and it's too tall. It looks like a s9650 will work, but I'm not finding a spec sheet on the net that confirms the height from the "bottom of the ears to the bottom of the case". Instructions state 19-22mm.
I have a futaba s9602 and it's too tall. It looks like a s9650 will work, but I'm not finding a spec sheet on the net that confirms the height from the "bottom of the ears to the bottom of the case". Instructions state 19-22mm.
By ears, means support to mount the servo inclined!
#64
Tech Regular
9650 fits fine
#65
Has anyone tried the KO 949? I believe Moore is sponsored by KO so it would only make sense. Perhaps I am wrong though.
#66
#67
Hara runs fro Futaba...here is a pic of his car at the IIC, can't realy tell what brand. I have a Futaba 9650 in my C12 and have used 9602s in the past w/out any problems.
#69
c12
where can i buy this car?
#72
#74
This is such a ridiculous statement. Between here and Rcracing.com,you have thrown up so much unwanted personal opinion,its getting old.For a kid who has been racing for less then a year,never has run 12th scale,barely competitive in the class you do run in,you sure have an opinion on everything you have no idea about.Billy needs to get you in check.
I guess no one on the net can take a joke, or get me...... If you ever see me, I think you would get it..... And then you and Russ would both laugh Everyone on the net takes everything the wrong way, well here, and rc racing
I did too... lol
#75
That's a Futaba 9650 servo in the car. Out of the box the C12 is very good.
For big races I have to use an OD12 which feels lazier than the C12, but the lap times are the same.