What is this used for?
#1
What is this used for?
My "new to me" MRX-3 came with a new Racerchoice lola body. It came with these odd parts and no instructions as to what they are used for.
5 lengths of plastic and a bag of rivets. Please see pic...
5 lengths of plastic and a bag of rivets. Please see pic...
#2
You dont know what they are for?
The 4 little pieces are the body stifferners & the other is the wing.
The body stifferners need to be bent at the lines marked then attached to the body with the rivets, behind the front wheel & in front of the back wheel. You should know where the wing goes.
The 4 little pieces are the body stifferners & the other is the wing.
The body stifferners need to be bent at the lines marked then attached to the body with the rivets, behind the front wheel & in front of the back wheel. You should know where the wing goes.
#3
Gracias...
Sorry for my ignorance and "newbness" but I have only dealt with touring shells in the past...
Sorry for my ignorance and "newbness" but I have only dealt with touring shells in the past...
#4
Originally Posted by BIGTACO
Gracias...
Sorry for my ignorance and "newbness" but I have only dealt with touring shells in the past...
Sorry for my ignorance and "newbness" but I have only dealt with touring shells in the past...
Thanks
Loren
#5
Originally Posted by BIGTACO
Gracias...
Sorry for my ignorance and "newbness" but I have only dealt with touring shells in the past...
Sorry for my ignorance and "newbness" but I have only dealt with touring shells in the past...
#6
hehe...oh I will. Lets just hope I can stay off the ways
#7
There's also a whole article on the Serpent website about how you can use the stiffeners to make the rear of the body slightly wider than the front, thus being more aerodynamic.