Yokomo MR-4 TC Thread
#1591
Tech Elite
iTrader: (12)
have all the mr4 drivers switched cars all of a sudden?
#1592
R/C Tech Founder
I love carpet racing too. Outdoors/pavement is not bad, but carpet is just too cool.
Team Yokomo is officially running the Special at the Worlds, so there's no argument that it's a good car. They are using *molded* pieces with the Tosolini camber mods, so I would expect to see those hitting shelves in a few months.
My 1-2-3 picks for the Worlds:
Masami
Hara
Lemieux
Team Yokomo is officially running the Special at the Worlds, so there's no argument that it's a good car. They are using *molded* pieces with the Tosolini camber mods, so I would expect to see those hitting shelves in a few months.
My 1-2-3 picks for the Worlds:
Masami
Hara
Lemieux
#1593
Check this out on Ebay!
#1594
so, no new car huh?
I never did get the car to really work with the camber mods, though that was towards the end of the season.
Speedo
I never did get the car to really work with the camber mods, though that was towards the end of the season.
Speedo
#1595
Tech Elite
iTrader: (12)
Josh- mine is awesome with the camber mods. The guys here just can't get over how glued the car is. Also, when I went down to Louisiana, I didn't even tune the car, just threw it on the track and it was hooked. Although, it needed some tuning for foam, but I was lost for a foam set up and didn't even try to tune it. I just ran it like it was.... it was still good though.
I got a used Mission to try so I can compare the two. I'm curious to see how hard it is to get the Mission to be as good as the Yoks... if I can even get it to be that good.
I got a used Mission to try so I can compare the two. I'm curious to see how hard it is to get the Mission to be as good as the Yoks... if I can even get it to be that good.
#1599
P# ZR-007 for the front kingpin ballstud setup.
I know my LHS has them, you might want to send an email to speedtech; I don't think they have them listed on the site but they may have them.
For the rear, you will have to make the parts yourself, I don't think the molded pieces are out yet.
Speedo
I know my LHS has them, you might want to send an email to speedtech; I don't think they have them listed on the site but they may have them.
For the rear, you will have to make the parts yourself, I don't think the molded pieces are out yet.
Speedo
#1602
LHS is West Coast Hobbies; (509) 375-4995
#1603
You could call yokomo USA, I think you can order stuff from them, though it is a little more expensive.