OCM KAOS DOMINATING
#2146
D8 shocks travel will normaly be to short to be good..
tq or jammin BB shocks are a good fit
tq or jammin BB shocks are a good fit
#2147
does the mugen front lower and upper arms fit perfect or are they off any
#2149
the stock ocm front arms seen like the flex bad are the caster any better and are they cheaper than the mugens
#2150
ocm arms to flexy..?
again they are real good, even too hard
if you change to mugens or another brand, you will alter the geometry
and it won't drive as good/different
lower mugen arms also will break more easy
again they are real good, even too hard
if you change to mugens or another brand, you will alter the geometry
and it won't drive as good/different
lower mugen arms also will break more easy
#2151
alright i will just get new ocm ones but i heard the older bulkheads are not good how can i tell if they are the old ones is there any way to see
#2152
new ones have curved antiroll-bar fixations
to avoid damage in rear-on collisions
and incoming conical gear goes straight in
not at an angle anymore...
ask Holeshots or special-rc on ebay
to avoid damage in rear-on collisions
and incoming conical gear goes straight in
not at an angle anymore...
ask Holeshots or special-rc on ebay
Last edited by speedy2; 12-30-2008 at 02:22 AM.
#2153
lets see some ocm pics
#2154
a OCM Evo 2009
central part
with epoxy brake linings
newest cnc main gear and diffhousing
central part
with epoxy brake linings
newest cnc main gear and diffhousing
Last edited by speedy2; 01-09-2009 at 11:32 PM.
#2155
gigi's Evo 2009
double brake upper links
and Proline airfilter
double brake upper links
and Proline airfilter
Last edited by speedy2; 01-09-2009 at 03:32 PM.
#2156
I mounted the new soft fr/rr arms featuring -2mm track reduction
to be used with +1/+2 mm hubextentions, so one can tune track
... personally I run with +0 hubs up front
reducing front track , creating more rotation..
DE protection shields for D8 share the same chassis holes..
replaced all 2.0 flathead screws with 2.5 capheadscrews for ease of assembly
even those holding together the bulkheads..really like it..
mounted the kyosho yellow springs but they are to stiff
to be used with +1/+2 mm hubextentions, so one can tune track
... personally I run with +0 hubs up front
reducing front track , creating more rotation..
DE protection shields for D8 share the same chassis holes..
replaced all 2.0 flathead screws with 2.5 capheadscrews for ease of assembly
even those holding together the bulkheads..really like it..
mounted the kyosho yellow springs but they are to stiff
Last edited by speedy2; 01-10-2009 at 07:06 AM.
#2157
2.0 flathead screws with 2.5 capheadscrews where do ya get them at i check the hardware store but all they have are the 2.0
#2158
at Tony's screws
#2159
the new OCM rtr
featuring the latest parts and GO based engine
featuring the latest parts and GO based engine
#2160
how much is that in us dollars