Serpent 748 200mm nitro onroad kit
#361
Tech Adept
Happy new year!!!
A happy new year to Switcerland!!!
It's a great family of RC to be a part of, Im just waiting on Andrew to join as well!!! The support here comes from Sydney and our mad goats will keep us going for a while longer!
Dan, let alex know, I am still trying to get all the Serpent footage from the worlds, but there's so much footage, my PC crashes or hangs for a while and Ive wasted countless hours away from renovations and other things. Its my new year resolution to get it done by the end of January and will send off the vision as promised.
It's a great family of RC to be a part of, Im just waiting on Andrew to join as well!!! The support here comes from Sydney and our mad goats will keep us going for a while longer!
Dan, let alex know, I am still trying to get all the Serpent footage from the worlds, but there's so much footage, my PC crashes or hangs for a while and Ive wasted countless hours away from renovations and other things. Its my new year resolution to get it done by the end of January and will send off the vision as promised.
Thääänk you!
A happy new year to all of you!
Is it right? Have you changed to the Serpent Team? :-)
#362
I thought you were talking about the set screws top and bottom that adjust the gap between the shoes and the bell housing. Now I understand you are talking about the 2 spring screws. Personally I didn't have an issue when setup correctly the screw heads are down far enough that they shouldn't protrude past the shoes.
#363
No no no... Would be nice, but the C02 kit we have is plenty good for us... Those enjoying Serpent who were at the worlds had plenty to enjoy too, everyone's cars looked good out there!
#364
Tech Adept
After finishing the build of the natrix I will start with the C03 :-)
#365
Tech Adept
Almost done...needs just a few things
#366
#367
Tech Adept
#368
Tech Adept
Now with engine
#369
Tech Regular
Looks good
#370
Tech Regular
Are there any coupons out there I'm going to purchase the 748 tomorrow from desoto.
#371
Tech Regular
I have an 18tz mod with ERCM pipe does anyone know of a good header for this combo or another pipe and header combo. Or another engine that you guys may be request going to be used for drag and parking lot speed runs.
#372
Tech Regular
Also I would like to know what steering and throttle and diffs oils and lipo pack. You guys suggest along with wheels. Or anything you may know I need before I start my build. I have a Futaba radio.
#373
Tech Regular
earlier in this thread people used sanwa ers-971 servo`s, 3 -to 500.000 front and 4 -to 80.000 rear (old diffs), for the newer diffs double the numbers, all depending on track offcourse. A Life pack is easier, so a zippy 700 or zippy 1100 battery.
#374
Tech Regular
Ok thanks rbakker