Losi 8ight building and setup
#2958
Tech Addict
iTrader: (4)
Vr6, the 3 degree toe and 2 degree antisquat is the stock rear hinge pin brace on the rear of the car.
3 toe/ 3 antisquat is LOSA1749
2 toe/ 2 antisquat is LOSA1747
I think a lot of us usually run the 3 toe/ 3 antisquat plate...
Has anyone had problems breaking the front steering spindle ends? I've seen alot of them snap on the inside and I broke one today.
LOSA 6046
Is there an alternative or has Losi updated them with a running change? They seem like the brittle part on the entire car. Other than that, me like!!!
3 toe/ 3 antisquat is LOSA1749
2 toe/ 2 antisquat is LOSA1747
I think a lot of us usually run the 3 toe/ 3 antisquat plate...
Has anyone had problems breaking the front steering spindle ends? I've seen alot of them snap on the inside and I broke one today.
LOSA 6046
Is there an alternative or has Losi updated them with a running change? They seem like the brittle part on the entire car. Other than that, me like!!!
#2963
I use the 3/3 from M2C. Does anybody else?
#2964
Tech Champion
iTrader: (1)
Any stronger alternatives? Or are you just replacing them with a new one?
http://www.horizonhobby.com/Search/D...SA+6046&CatId=
If so, then I don't know of any alternatives, and I myself haven't broken any of those, and I got my car back around Thanksgiving. At first your description sounds like these:
http://www.bmainhobbies.com/product_...oducts_id=2400
#2965
Tech Addict
iTrader: (4)
LOSA6046. They are a 4mm rod end and that's the second one I've broke and I've seen lots of others break them, all at very important times. I've heard Losi now has this as a running change since just before the Truggy was released but I was just trying to see if anyone knew an alternative or to confirm the updated part...
#2966
Tech Fanatic
Originally Posted by cwalters
Any stronger alternatives? Or are you just replacing them with a new one?
#2969
Tech Addict
iTrader: (4)
Not a problem Vr6. That is what this is all for.
XMS Racing, it sure would be nice if we could somehow get that Kyosho number for those rod ends. Even though I don't want to put a K car part on this Losi, I don't want to break everytime I stick the Eight inside on somebody
XMS Racing, it sure would be nice if we could somehow get that Kyosho number for those rod ends. Even though I don't want to put a K car part on this Losi, I don't want to break everytime I stick the Eight inside on somebody
#2970
Is width still ROAR legal with the +2 hubs?