EAMotorsports discussion thread
#5930
Eric, I'm jealous of ya'll, I'll be in Ohio, Big Fat Italian Wedding. Dirla is right, you will be getting no sleep in Terry's Ride. The first race we were up for 26 hours straight. I wish I could be there to see Skeen's reaction to that big ol track
Yall have fun, The Big Ragu
Yall have fun, The Big Ragu
#5932
Tech Master
iTrader: (21)
Scared? come on EA I go to a lot of big races to get my but kicked I'm not afraid of losing I'm quite comfortable with it LOL
You are the big time factory backed guy... I'm just a shmuck with a hobby shop LOL I don't have anything to prove
Dan... what's that supposed to mean?
You are the big time factory backed guy... I'm just a shmuck with a hobby shop LOL I don't have anything to prove
Dan... what's that supposed to mean?
#5933
Well Skeen, I hear the track isn't much bigger than The Thunder Dome....Deano's was a blast but because of Pro series rules they don't water, you boys better plan on pitting up wind, and bring plenty of air filters, gogles and a good resperator would not hurt...It's usually a Dust Bowl...
#5936
Tech Champion
iTrader: (13)
Just went out and tried the the new orion/peak 19T motor. So far I had rip over everyone on the track. The stock Q brushes are really good too. I tried F brushes... but they are a little much and start to fade at about 3 min. I'm going to try and get them to work, but I think Trinity xxx compound brushes will be really sweet. The best thing is... with the q brushes... it had rip the ENTIRE run. There was little or no fading through the run. So far this is my pick for 19T when it's not a handout motor race .
-Korey
-Korey
#5937
Tech Elite
iTrader: (5)
Just went out and tried the the new orion/peak 19T motor. So far I had rip over everyone on the track. The stock Q brushes are really good too. I tried F brushes... but they are a little much and start to fade at about 3 min. I'm going to try and get them to work, but I think Trinity xxx compound brushes will be really sweet. The best thing is... with the q brushes... it had rip the ENTIRE run. There was little or no fading through the run. So far this is my pick for 19T when it's not a handout motor race .
-Korey
-Korey
#5938
Tech Champion
iTrader: (13)
I was gearing at a 8.2 final drive... I think something around an 8.4-8.6 might have been a little better for the track. Most guys were running their komodo's at 8.0 final drive. I was using the stock springs... but I tweaked them a little bit. It's a rather small asphalt track on a pretty tight layout.
-Korey
-Korey
#5940
Brush Cutter & serrator
Hi EA
Just wondered if you can fill me in on what different cuts will do on brushes for a stock motor, just bought a Xipp brush serrator & cutter and want to know which cuts give more rpm, power etc and about timed cuts etc. I think i've seen em somewhere before but can't find the info I need even by serching.
Cheers for any help you can give
Paul
Just wondered if you can fill me in on what different cuts will do on brushes for a stock motor, just bought a Xipp brush serrator & cutter and want to know which cuts give more rpm, power etc and about timed cuts etc. I think i've seen em somewhere before but can't find the info I need even by serching.
Cheers for any help you can give
Paul