ORCA Team - VRITRA VX COMPETITON ESC
#169
This is what Blake is running latley in 17.5
Punch 10
Drive Freq 8k
Brake Freq 700%
Drag brake 3%
Initial Brake 3%
Punch 10
Drive Freq 8k
Brake Freq 700%
Drag brake 3%
Initial Brake 3%
#170
The 1S can do 2S right?
#172
Too bad.
#175
Tech Regular
1) Brake Freq...does this mean brake strength? is 2 KHz stronger than 1.1 KhX and so on?
2) PWM...this equates to max torque/rpm characteristics at specific engine RPM, thus 4K will deliver more torque at lower RPM than say 32 K, correct? Preferred for blinky?
3) Some say that they are using 3% Initial Brake, but I cannot choose 3% on the programmer card, only 2 or 4%, could it be that I have the wrong version S/W in the programmer box? It would seem that I have V.2 S/W in the programmer box & V2.2 S/W in the ESC...
Appreciate everyone's support.
Thanks!
#176
Setup is V3 paramaters, slightly different to V2
[QUOTE=mhavlena;11403540]To to confirm:
1) Brake Freq...does this mean brake strength? is 2 KHz stronger than 1.1 KhX and so on?
*Other way around, also has a feel about it too.
2) PWM...this equates to max torque/rpm characteristics at specific engine RPM, thus 4K will deliver more torque at lower RPM than say 32 K, correct? Preferred for blinky?
*Not sure on blinky but will effect gearing and motor heat. Try each for punch and feel.
3) Some say that they are using 3% Initial Brake, but I cannot choose 3% on the programmer card, only 2 or 4%, could it be that I have the wrong version S/W in the programmer box? It would seem that I have V.2 S/W in the programmer box & V2.2 S/W in the ESC...
*Its a V3 thing, but once again try either way for feel!
The latest speedys are shipped with V3 so the update wont be too far behind.
We are trying to get the original V2 as a download so we can go between the two configs...
cheers...
1) Brake Freq...does this mean brake strength? is 2 KHz stronger than 1.1 KhX and so on?
*Other way around, also has a feel about it too.
2) PWM...this equates to max torque/rpm characteristics at specific engine RPM, thus 4K will deliver more torque at lower RPM than say 32 K, correct? Preferred for blinky?
*Not sure on blinky but will effect gearing and motor heat. Try each for punch and feel.
3) Some say that they are using 3% Initial Brake, but I cannot choose 3% on the programmer card, only 2 or 4%, could it be that I have the wrong version S/W in the programmer box? It would seem that I have V.2 S/W in the programmer box & V2.2 S/W in the ESC...
*Its a V3 thing, but once again try either way for feel!
The latest speedys are shipped with V3 so the update wont be too far behind.
We are trying to get the original V2 as a download so we can go between the two configs...
cheers...
#177
.
Last edited by azwan; 11-07-2012 at 05:39 PM.
#178
Tech Adept
#180