what type of fuel i need??
09-15-2009, 12:17 AM
#32
the drill should be in FWD
09-15-2009, 12:20 AM
#33
yes the piston is moving when i spin the drill. when i spin the drill counter clockwise the piston moves but clockwise it doesnt. is my clutch bad?
09-15-2009, 12:22 AM
#35
Tech Master
I think the motors shot.
Your clutch is fine for sure.
Your clutch is fine for sure.
09-15-2009, 12:22 AM
#36
fwd as in foward? when i put it in foward the piston doesnt turn but when i do it in unscrew the piston moves
09-15-2009, 12:29 AM
#37
has the backplate/one way bearing ever been taken out?
09-15-2009, 12:30 AM
#39
no it hasnt
09-15-2009, 12:30 AM
#40
yes it does have fuel
09-15-2009, 12:32 AM
#41
im gonna say the one-way is worn out, as im pretty sure the drill needs to spin in foward...but its been awhile since i used one
09-15-2009, 12:38 AM
#42
on youtube i see trucks having the pull start and it looks like its going foward when they start it
09-15-2009, 12:40 AM
#43
yeah, a drill is very hard on the bearing
if the engine is flooded (the piston cant move) the drill still tries to spin it over causing the one-way bearing or the starter shaft to wear out
if the engine is flooded (the piston cant move) the drill still tries to spin it over causing the one-way bearing or the starter shaft to wear out
09-15-2009, 12:45 AM
#44
i see but why does it turn the engine when i reverse it? do u suggest to buy a pull start? or get the same setup?
09-15-2009, 12:49 AM
#45
barely...it should be spinning as fast as the drill if it were catching