Go Back  R/C Tech Forums > General Forums > Nitro Off-Road
storing fuel on floor? >

storing fuel on floor?

Community
Wiki Posts
Search

storing fuel on floor?

Thread Tools
 
Search this Thread
 
Old 04-15-2008, 11:13 AM
  #1  
Tech Regular
Thread Starter
iTrader: (22)
 
Join Date: Dec 2007
Posts: 419
Trader Rating: 22 (100%+)
Default storing fuel on floor?

I know the best way to store fuel is off of the floor.
I always store it high on a shelf

I'm just wondering what happens to the fuel when it is stored on the floor?
phixd is offline  
Old 04-15-2008, 11:51 AM
  #2  
Tech Regular
iTrader: (4)
 
Join Date: Apr 2008
Location: OC, So Cal
Posts: 484
Trader Rating: 4 (100%+)
Default

It will pull up moisture from the floor.
largeorangefont is offline  
Old 04-15-2008, 12:30 PM
  #3  
Tech Champion
iTrader: (1)
 
R40Victim's Avatar
 
Join Date: Jan 2005
Location: N.W. FL___L.A.___Lower Alabama
Posts: 7,831
Trader Rating: 1 (100%+)
Default

Uh, not unless you leave the cap open...

Try to keep it in a place with minimal temperature fluctuations. The moisture comes from what's inside the bottle already. The nitro pulls it from the small amount of air inside the container. It won't pull water through the plastic container and inside the jug. So it doesn't matter if it's on the floor, ceiling, or nailed to a wall. As long as the temperature doesn't fluctuate, and the container remains sealed, it will last a pretty long time.
R40Victim is offline  
Old 04-15-2008, 12:40 PM
  #4  
Tech Addict
iTrader: (8)
 
Crim3Wav3's Avatar
 
Join Date: Dec 2005
Location: MasshoL3
Posts: 715
Trader Rating: 8 (100%+)
Default

from John Howell at RC Car Action:

here's the deal regarding proper fuel storage:

1. When at the track or outdoors, make sure that you keep your fuel out of direct sunlight. If it sits in the sun for extended periods, the fuel's methanol can easily evaporate, and the fuel will lose its "oomph."

2. When storing fuel, keep it off a concrete floor. Concrete can "leech" the nitromethane content from the fuel's plastic container as if it were a sponge.

3. When you aren't using your fuel, make sure that the included insert cap is fully inserted under the screw-on cap.

4. Store the fuel in a dry, cool place. Putting it in the fridge is a little overkill, but Trinity does make some pretty nifty Nitro Kooler bags that help the fuel stay cool, and that prevents the nitromethane from evaporating through the bottle.

In addition to these guidelines, just try to use your fuel in a timely manner; it isn't exactly as drastic a change as when milk goes bad, but over time, it will lose its potency.

Copyright Air Age Publishing Jul 2003 (LOL)
Crim3Wav3 is offline  
Old 04-15-2008, 01:37 PM
  #5  
Tech Master
 
RBMike's Avatar
 
Join Date: Jan 2007
Location: Santa Clara CA
Posts: 1,264
Default

Just burn a couple of gallons a month & you don't have to worry about how it's stored.
RBMike is offline  
Old 04-15-2008, 02:53 PM
  #6  
Tech Champion
iTrader: (1)
 
R40Victim's Avatar
 
Join Date: Jan 2005
Location: N.W. FL___L.A.___Lower Alabama
Posts: 7,831
Trader Rating: 1 (100%+)
Default

Concrete can "leech" the nitromethane content from the fuel's plastic container as if it were a sponge.
Hang on just a second... How the hell can it go THROUGH the plastic?
R40Victim is offline  
Old 04-15-2008, 03:00 PM
  #7  
Tech Regular
iTrader: (4)
 
Join Date: Apr 2008
Location: OC, So Cal
Posts: 484
Trader Rating: 4 (100%+)
Default

It cant.

If you leave it on concrete you can get condensation inside the bottle, and water in your fuel. If you leave it in the sun the fuel can lose some of its punch.

Store it in a cool, dry place off the floor and you will be fine.
largeorangefont is offline  
Old 04-15-2008, 03:58 PM
  #8  
Tech Regular
iTrader: (1)
 
Join Date: Apr 2008
Posts: 334
Trader Rating: 1 (100%+)
Default

A nice trick I like to use is to squeeze your container until the fuel is almost ready to pour out, then put the cap on nice and tight. This makes it so that the insides of your fuel container is 99% fuel, 1% air. Where a normal way is to unintentionally have it 50/50.

I also usually pour my fuel into a 2L bottle once my normal 4L container gets half empty, then into a 1L bottle from there.

Im not 100% sure if that does anything, but Ive never seen condensation form in my bottles using this trick, but I have seen condensation form just by storing it normally.
Attached Thumbnails storing fuel on floor?-fuel.jpg  
new to rc cars is offline  
Old 04-15-2008, 07:22 PM
  #9  
Tech Lord
iTrader: (8)
 
Integra's Avatar
 
Join Date: Dec 2006
Posts: 12,489
Trader Rating: 8 (100%+)
Default

Nice drawing new to rc cars.
Integra is offline  
Old 04-15-2008, 07:48 PM
  #10  
Tech Regular
iTrader: (1)
 
Join Date: Apr 2008
Posts: 334
Trader Rating: 1 (100%+)
Default

Originally Posted by Integra
Nice drawing new to rc cars.
Thank you.

Were you being sarcastic, or was it actually a helpful drawing?

It (obviously) only took me 20 seconds do to, but Im sure it gets the point across... right?

Does that actually help with the fuel and condensate?
new to rc cars is offline  
Old 04-15-2008, 07:55 PM
  #11  
Tech Master
iTrader: (5)
 
Join Date: Sep 2007
Posts: 1,080
Trader Rating: 5 (86%+)
Default

Whoa...squeezing out air. Can we buy those 'drip reservoirs' (I dunno what they call 'em) like those hospital patients use to store our fuel?
razor_clawzz is offline  
Old 04-15-2008, 10:11 PM
  #12  
Tech Regular
iTrader: (1)
 
Join Date: Apr 2008
Posts: 334
Trader Rating: 1 (100%+)
Default

Originally Posted by razor_clawzz
Whoa...squeezing out air. Can we buy those 'drip reservoirs' (I dunno what they call 'em) like those hospital patients use to store our fuel?
An IV drip bag, why would you wanna do that?
new to rc cars is offline  
Old 04-16-2008, 12:30 AM
  #13  
Tech Master
iTrader: (5)
 
Join Date: Sep 2007
Posts: 1,080
Trader Rating: 5 (86%+)
Default

Originally Posted by new to rc cars
An IV drip bag, why would you wanna do that?
Someone said squeezing out air will keep your fuel fresh, as there's no air to condensate. I can't squeeze a 1gal fuel bottle
razor_clawzz is offline  
Old 04-16-2008, 01:18 AM
  #14  
Tech Regular
iTrader: (1)
 
Join Date: Apr 2008
Posts: 334
Trader Rating: 1 (100%+)
Default

Originally Posted by razor_clawzz
Someone said squeezing out air will keep your fuel fresh, as there's no air to condensate. I can't squeeze a 1gal fuel bottle
Not strong enough or what?

if its near half, fill your gas tank, fill your fuel bottle, then pour the rest into a 2L pop bottle, then squeeze that each time you fill your fuel bottle!
new to rc cars is offline  
Old 04-16-2008, 04:23 PM
  #15  
Tech Regular
iTrader: (3)
 
Join Date: Feb 2008
Posts: 398
Trader Rating: 3 (80%+)
Default

i buy traxxas fuel it comes in a metal can that gets noisy when theres a temp change when the fues is half gone do i have to worry about storing it on the floor too
chris_smith is offline  


Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.