strange question about screw size
#1
strange question about screw size
what size is the set screw the is in the end of an OS pipe. the screw i am looking for is the screw that secures the pipe wire at the end of the pipe
#2
Not sure about OS. Most use a 4mm set screw. Some use an even bigger one, 5mm I think.
Last edited by wingracer; 07-13-2009 at 12:14 PM.
#5
#6
Tech Elite
iTrader: (57)
Not a team driver, I cant take any of that credit.
I have a 2060 on my buggy and the setscrew takes a 2.0mm hex driver, in general most of your rc fasteners that take a 2.0mm driver are 3mm in thread diameter, with the exception of a socket head cap screw. They take a 2.5mm driver, along with all the 4mm flat socket screws on the bottom of your chassis.
I have a 2060 on my buggy and the setscrew takes a 2.0mm hex driver, in general most of your rc fasteners that take a 2.0mm driver are 3mm in thread diameter, with the exception of a socket head cap screw. They take a 2.5mm driver, along with all the 4mm flat socket screws on the bottom of your chassis.