Team Orion .21 CRF Question
#2
I used the Orion 2066 pipe. You can't go wrong with this pipe
#3
Tech Regular
where i can buy team orion pipe?
#4
hey jimmy your the reason why im getting the crf. i saw you run it at the rc driver race in enfeild CT. you also gave my little brother your trophy at the end of the race. thanks for the reply and do u know where i can get that pipe. i cant find it anywhere thanks
#5
Wow Hawk498 I just got teary-eyed. That means alot to me. I'm pretty sure you can buy direct through Orion/Kyosho. I'll double check come Monday for you. If you have any questions regarding this engine I'm here to help. I know they just got some back in stock
#6
thanks alot jimmy i will deff take use of you help when i get the engine.i have huge hopes for it for next year. at the rc drive race i had engine problems and dnf but my bro won me a vspec and i used that and great luck with it the rest of the year, but its time to go faster. are you planning on coming back to rc madness next year for the race or is it to early to tell?
#7
Hawk I'm always here to help. As far as the RC Madness race for next year, it's too early to tell. I only race a few times a year. It just so happen that I was able to get that weekend off for the RC Driver race this year.
#8
Tech Addict
iTrader: (7)
Hey all, hate to bring up a old thread but I have the same question. I just picked up a non-us spec crf .21 and would like to know what budget pipe works good with this engine. Like any of the ofna pipes. I see some people have used the AE 2035 but every place I see that sells it it doesnt come with a header, what header works with the AE pipe. Will the ofna 053 or 086 work well? What about the losi pipes? I budget pipe, meaning not a $100+ pipe
#9
pipe
I have run one with a jp-1 with great results ,would also like to try a jp-3 , you just need to bend the header a littlle to keep the pipe down due to the angle of the rear port on the motor.
#10
The 9886 pipe works well on the CRF .21 engine as well as the 2066. I have found the 9886 does provide better run time though and delivers a more linear power band.
#11
Tech Adept
i run the jp-3 the engine is fully awsome ive got like two and a half mabey three gallons on it and it still locks at the top if not warm
#12
Tech Rookie
Another question about this motor
I just got one of these and the crank shaft has a little play/slop in it. My OS motor doesn't have any give at all is this something that is common with these motors?
Thanks
Rob
This was also asked in the forum, but I found this thread and put it here too.
Thanks
Rob
This was also asked in the forum, but I found this thread and put it here too.
#13
086 and JP4 work awesome
2035 is a POS on this motor.... absolutely kills the top end.. 2035 and Picco engines dont mix well if you ask me
2035 is a POS on this motor.... absolutely kills the top end.. 2035 and Picco engines dont mix well if you ask me
#14
I need the factory needle settings for this motor. Anybody have them?