Skeeter36

iTrader: (32)

good ones are not cheap I believe someone posted a pic and a link in this thread awhile back.

Racing4Evo

iTrader: (2)

http://www.teameamotorsports.com/ind...product_id=181

Moyanator609

iTrader: (4)

ok,,, ive seen it all. lol

motoman811

iTrader: (15)

I just picked up a titanium screw kit and am wondering if there is anywhere I should avoid using the screw?

AZJP

iTrader: (21)

Not really. ----, I put a AE FT Ti kit in my car and I'm thinking about if there is a single screw that isn't titanium besides the diff screw. Pretty much everything besides the hinge pin screws will be replaced.

barry1me

iTrader: (9)

so is everyone running the RM arms on there MM cars?

QDRHRSE

iTrader: (515)

Thank you so much for the link!

All the parts came to build my 3 gear trannys. Anybody have an opinion that has tried one? A few guys at the track are running them and say they're great but it seems like, based on what I know, it would cause a loss of forward grip. I'm going to try one out I guess.

lee111m

I was wondering if someone had a top shaft lying around and could count the teeth and measure how wide the gear is.

QDRHRSE

iTrader: (515)

I have a car running each. Its hard to say.....when traction is up the MM front arms might even give you too much steering but on the other hand the RM rear arms don't feel as good when there's lots of traction. I think its a personal preference thing. That being said, pretty much every set up sheet you see from the team guys uses the RM arms.

Cpt.America

iTrader: (52)

I would use the stock hardened steel screws for the top mounts of your shocks. Ti or Alu screws will tend to bend there. Everywhere else, go for it.

gogi108

iTrader: (9)

Ran my b5m last weekend , rm arms on the rear , 1.6 all round 27.5 32.5 oils everything else b9x stock us8ng a trackstar 17.5 , the car is beast got second overall to a serious stock racer pucks ti screws ect , would love to go all out on this car but with the ft lite just around the corner would be a waste , either that or the yz2 which looks an awesome car at our track !!!

Moyanator609

iTrader: (4)

Just picked up tekin rsx gen2 with 7.5 motor. Any gearing suggestions??? I have extra 81t spurs laying aroung and a few 21t,20t,19t pinions too.

RC*PHREAK

iTrader: (146)

carpet guys, what are you using for front wheels with those skinny carpet tires? the only ones i can find are the schuey's and it looks like the hole for the axle is too big.

AZJP

iTrader: (21)

The manual tells you what the gearing should start at.

I bounce between 21-23/81 with a 7.5.

iTz Nicholas72

iTrader: (19)

Cut the inner rib off a standard front wheel.