SWAY BARS
03-24-2009, 09:03 PM
#1
SWAY BARS
I put a set of Tekno sway bars on my slayer and the brake rod with the adjuster hit the sway bar mount can't let off brake all the way it binds up any suggestions
03-25-2009, 02:40 PM
#2
Trim/shorten up the brake linkage so the adjuster is moved closer to the pull eyelet.
Or find a smaller adjuster barrel/knob.
You can shorten the rod and put a new z-bend or just a bend and a collar on the end of it to retain it in the servo horn. Or if they have enough threads on the end; just dremel a bit off that end, no bending req'd.
Or find a smaller adjuster barrel/knob.
You can shorten the rod and put a new z-bend or just a bend and a collar on the end of it to retain it in the servo horn. Or if they have enough threads on the end; just dremel a bit off that end, no bending req'd.
03-25-2009, 04:02 PM
#3
Thanks i took today and swapped around the servo horn and that helped a lot but i will cut some off with dremel thanks
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
