Hyper TT 4wd 1/10th Truggy Thread
#1846
#1847
got mine to the track today crazy fast geared it down to a 12 on pinion with novak 4.5 hv 550 can first turn hit the pipe and upper lower arms pulled through the hub went right back in though only problem i see is no free roll off throttle u let go and it wants to stop anyone else have this problem
#1848
got mine to the track today crazy fast geared it down to a 12 on pinion with novak 4.5 hv 550 can first turn hit the pipe and upper lower arms pulled through the hub went right back in though only problem i see is no free roll off throttle u let go and it wants to stop anyone else have this problem
#1849
Will check it thanks
#1850
Tech Adept
iTrader: (14)
Make sure your ESC has the drag break is backed off - I have mine set to 0 to get it like I want it.
Not sure what your used to driving but it is way different then any 2WD -
Gear mesh you need a good amount of backlash there - set it up similar to a nitro in terms of clutch bell to spur backlash is what I find.
Not sure what your used to driving but it is way different then any 2WD -
Gear mesh you need a good amount of backlash there - set it up similar to a nitro in terms of clutch bell to spur backlash is what I find.
#1851
Thanks will check novak and see I think it was off though mes is set with alittle play between gears so should it b more I started with 2 hyper 10 sc so a little use to them but this thing nose dives hard if you dont stay in throttle
#1852
Tech Addict
iTrader: (1)
I'll post a more inclusive review tonight or tomorrow, but I installed the new Castle 4600kv 4 pole motor in mine last night. It's tiny but NASTY. I ran it for about 5min. in the street hard on the throttle and brakes and it only got up to 95 degrees. Speedwise it felt almost as fast on 2s as my 3600kv Neu motor does on 3s.
#1853
Tech Adept
iTrader: (14)
I also reduce the minimum break to about the lowest setting as well -
I know with the Kinetic ESC and NovaLink I can unlink the two otherwise they seem to affect each other (drag break and minimum break).
#1854
I was excited to pick up my tt today and race it tomorrow but it came with a broken front arm in the box. they screwed the lower pillow ball in too far and cracked the arm
#1855
#1857
#1858
nice and clean looks great
#1860
s/xrunner thanks for the videos you still running losi ten conversion i wish i would have bought your hyper tt that thing was off the hook mines coming along though
is there a way to unmount the tires and change the foams or do i have to buy everything new and what tires and foams are good
is there a way to unmount the tires and change the foams or do i have to buy everything new and what tires and foams are good