Kyosho Ultima RB6 & RB6.6 Car Thread
|
|||
#2057
Moderator
iTrader: (470)
Join Date: Nov 2009
Location: North Carolina by way of SoCal!
Posts: 4,785
Trader Rating: 470 (100%+)
A plastic insert would be awesome.
#2058
can somebody tell how much wider are the wide rear end hinge pin holder compered to standered ones i broke the wide ones all i could find the regular ones for now at least i can still run it
#2060
thanx capt steering is not a problem almost too much im running vectors on the front i have run them backwards to tame it down a bit!
#2061
Moderator
iTrader: (470)
Join Date: Nov 2009
Location: North Carolina by way of SoCal!
Posts: 4,785
Trader Rating: 470 (100%+)
Ooops, I thought the wider ones gave more rear traction.
#2063
Tech Adept
#2064
Thanks everyone for the support. We appreciate it very much. More great things to come...
Coupon codes in the sig.
Cheers,
Jeff
#2066
#2067
#2068
Tech Elite
iTrader: (14)
I think modeling clay or anything that doesnt become solid would end up pushing out around the chassis on impact and the chassis would do the same thing. My chassis hasnt done this and ive had lots of hard hits. The plastic insert seems like the best fix. Other then that im thinking of putting a small amout of JB weld in there then mounting just the transmission to the chassis, cleaning up what ever excess weeps out around the tranny and letting the JB weld set up for about 30 minutes then i'll remove the chassis and let the JB weld cure the rest of the way which will make it so the tranny doesnt become welded to the chassis. If i do this i will let everyone know how it goes. If any of you have opinions or ideas on this method please post them.
#2069
Fixn start my build anything I need to know or do?!
#2070
Tech Elite
iTrader: (6)
I think a thin 1mm or so skid plate might be the best option for now. I would prefer to see a plastic plate rather than a metal one. Mush lower cost I would assume with plastic over metal.
Maybe some company will make something to fill the gaps or a skid plate of some sort.
Maybe some company will make something to fill the gaps or a skid plate of some sort.