R/C Tech Forums - View Single Post - Adam Drake talks about the new 8ight 2.0
View Single Post
Old 11-25-2008, 05:28 PM
  #267  
DirtyDezPirate
Tech Fanatic
iTrader: (14)
 
DirtyDezPirate's Avatar
 
Join Date: Jun 2007
Location: Southern Califorina
Posts: 812
Trader Rating: 14 (100%+)
Default

Originally Posted by Adam Drake
DirtyDezPirate- What clutch set-up are you running? Try richening the hsn even more. When are you going to Rev next?

losi_racer- I don't get out to The Nitro Pit that often. It's a five hour drive. What engine are you running? Try the following clutch set-up. 13/48, make sure you sand the inside of the clutch bell and spray all the oil / grease out of the bearings. I use Losi bearings and the following clutch set-up: two plastic shoes with green springs and two alum shoes with gold springs.
Adam, I am using same clutch setup that you have been running, green on compose, silver on aluminum.. UHmm.. next time i be at revo, not sure?? only time i can is on weekends.. whens the next event at revo?
DirtyDezPirate is offline