Dino_D

Durango Hex Mod
I didn't like using the threadlock method. Aftermarket clamps are great, but I thought maybe a DYI mod would do the trick.

Thought I might share it with you guys. You just need part #704046








Test to make sure the screw sits flush in the hex or the wheel can't fit on.
You need to shorten the pin slightly so that the screws can clamp onto the hex and not protrude out. If you can't put the wheel on, either the pin is too long or the holes for the counter sink is not deep enough.




Trim any flashing so that the pin can slide in easily.