Originally Posted by
Rango Racer
i run rulux on both my 410 and 210
for the rears ya just needa groove the channel out for the pin to fit (and do the pin set up if need to)
and fronts on the 210 ya machine the 5mm shaft done to 4.4mm (what eva the b4 id bearing are) and run the b4 bearings
Thanks for the idea but I dont have the ability or access to machinery to machine down the front shafts.
As for the rest of the posts on the wheels, thanks and keep them coming.
I emailed Jconcepts and will wait for a response from them.