R/C Tech Forums - View Single Post - Hpi Pro 4
Thread: Hpi Pro 4
View Single Post
Old 07-20-2004, 07:21 PM
  #6263  
azenis
Tech Master
 
azenis's Avatar
 
Join Date: May 2004
Location: Hobart, Tasmania, Australia
Posts: 1,504
Default
Originally posted by Thad Garner
azenis,
We sometimes use o-rings and concave washers on the steering post screws to eliminate and possible tweak when using the 2.0mm chassis. This isn’t as necessary with the 3.0 and 2.5mm chassis. The reason he is using the Washes and counter sunk screws on the gear box is because he was using the Carbon fiber braces.
Thanks for that Thad How does it reduce tweak?
I run a 3mm BMI chassis on tarmak, so I guess I dont need them
I havent found any setup sheets on the net for 3mm esp for asphalt, do you know of any?
TIA
azenis is offline  
Reply