R/C Tech Forums - View Single Post - BMI Racing "Copperhead 12" discussion and support
Old 11-21-2011, 08:04 PM
  #2243  
Infinite 12th
Tech Fanatic
iTrader: (3)
 
Infinite 12th's Avatar
 
Join Date: Aug 2011
Location: California
Posts: 877
Trader Rating: 3 (100%+)
Default

Originally Posted by markiemark
Finaly got some time to work on the car before sunday and just wanna go over a few things with the jacos im going to run i had to add 1.5mm of shims to the left non spur side and then had to add 3.5mm of shim to the right spur gear side. Am i close to the rest of you guys wanna make sure im right and dont have anything messed up... Gives me a track width of roughly 171.5mm (not the worlds greatest caliper only goes to .1 of a mm).

Also as i just went over the front end i noticed the king pins are tight in the steering blocks so reamed them out with a 1/8 drill bit by hand.


Also does anyone know if there are copperhead stickers?? i seen the tshirt on bmi and plan to order it but also wanted some sticker but couldnt find them. Im only one at the track thats running bmi and wanted people to know it as most are crc xl and xi and 12r5.1
The kingpin doesn't slid inside the steering block so that doesn't matter

171.5 is perfect

Someone's looking for a sponsor ...lol
Infinite 12th is offline