I have an SP V2.1EX. I use it in a 1S 1/12TH scale car, I have been trying to put it in Blinky mode. I downloaded the 508 "No Timing" software and sent the settings to the ESC. When I turned it on I had steering, but no motor. A green light at the bottom of the ESC would go blink, blink, pause, blink, blink, pause. I could not activate the LCD programming box until I hooked up a 2S LIPO. The LIPO cell select adjustment is not operable. It is set on auto detect, but apparently does not do that. I set the voltage cut off to "No Protection". Now it runs, but the light at the bottom of the ESC does not blink. It is just steady red. With the 323 software I was able to set the voltage cut off to 3.0 and operate without any problem. What am I doing wrong?