Originally Posted by
aussierevo
I'm attempting to set-up a speed passion citrix with a 21.5V2.
I've changed the spur gear to a 35T and I'm attempting to attached a 34T pinion, but for the life of me the pinion simply doesn';t have enough room....I'd be lucky to get a 20T on. That, and the fact the motor hit's the post at the end so no room for movement.
how are people getting motor and pinion to fit to give a half decent rollout/fdr.
Your going to have to shave off a portion of the upper deck near the rear left post... Just dremel off from the bottom but not too much so you can still attach from the upper screw into the post... this will allow you more movement with the motor...