Ive now had a good few hours with the car... orsm is all I can say.
Ball cups , Ive had a few pop off but all in all thats because I crashed or hit something. Make sure that you have them at 90* to both ball studs that they are connected to that way they have a little play.
When you build them use grease and if you can out one end in a drill and slowly drill them in and out several times. Even after this I may need to hold/press down on one of the ball cups with my fingers while adjusting them.
Diff, no problems here, build it right and run it in and enjoy, its still smooth.
I use the ace 1015, maybe a little overkill but made a difference as it weighs more than the savöx low profile
And I fited tamiya battery holders and reamed out the stock battery holder so now I can use body clips instead of thumb screws, really easy
Last edited by onekiwi; 11-15-2011 at 12:53 AM.