Originally Posted by
dameetz
Guys, I m rebuilding my car with the 2.25mm chassis that arrived today. I just noticed there's a gap between the upperdeck and the motor mount (at the upperdeck middle screw to the motor mount). I never noticed this with my 2.5mm chassis, maybe I didn't check it before. So is this normal? If I screw it in, wouldn't the upperdeck tweak?
Below is the pic I took, and that is when the front and rear part screws are all in. I untweak the chassis on the Hudy block and the chassis looks normal, all flat.
Normaly, we screw now screw in that hole...
But this "problem" also exists with 2,5mm - it isn't a 2,25mm issue
sometimes it "can" be possible that the middleshaft bearing holder is to big, so you have to cut off some material from the top - otherwise, the topdeck bends.