Losi L8ight engine mount problems Help??
On a L8ight has anyone run into problems with the clutch bell not extending long enough to align with the Spur gear? I have two O.S. motors here and the bell gear is at least 2mm too short from making full contact with the spur gear. The bell gear is flush with the end of the engine shaft too. No shims on the end. I never seen anything like this. This L8ight is all original including mounts. I can reach half the width of the spur gear with the tip of the bell gear but need about 2mm to make full contact. There must be a issue with the mounts because it appears the crankshaft itself is not long enough. Got any ideas?