R/C Tech Forums - View Single Post - Pro 10: 235mm Le Mans Prototype Pan Car Discussion
Old 10-21-2011, 04:30 PM
  #360  
2wdrive
Tech Master
 
2wdrive's Avatar
 
Join Date: Mar 2009
Location: The Netherlands
Posts: 1,316
Default

Originally Posted by LOW ET
i just won this rc10l2 on ebay, what are the suggested upgrades to to make it pro10 worthy?

The rc10l2 is a pro10 so you don't need anything to make it into a pro10.

First get some servo posts . I bought aftermarket aluminium posts from Liquid rc.

Buy the original large Kimbrough servo saver as well. The one in the picture is not the original kimbrough saver that is included in the kit. Just rebuild it like the manual and it should be ok.
Remove the nerfbars. Get some carbon or frp ride hight shims for the front if it isn't included. It is very handy.

Some might disagree but i would get a TRF shock or something similar. It works better then the old asso shock imo. Put some teflon tape on the topplate where the friction disks are. That is pretty much it. You can drive it the way it is.

If you want some more setup possibilities you can make a rc10l2.5 later. When the axle breaks you can look for the IRS axle and hubs. They last a long time.

Last edited by 2wdrive; 10-21-2011 at 04:43 PM.
2wdrive is offline