What will stop a m05 from diffing out?
My car is very stuck and drives good.
I could not make it traction roll
if you paid me
...but it will lift the inner front tire on a hard corner
and unload the ball diff.
I have tried messing with oil and gave a rear bar a shot but it will
still unload bad and I loose all corner speed.
Only help so far has been a TIGHT diff. but I get too much push on corner out.
What should I adjust 1st,2nd,3rd ect...
current setup.
m05 pro
weight 1252
silvercan
ball diff with m03 cvs
Option front alum. tower with shocks in 2nd hole from center.
trf shocks 3 hole 45 front 35 rear,no orings/spacers in front shocks (full droop) 1oring in rear shocks.
front blue rear red spring
lower hole on the rear hub link.
spec tamiya premount rubber (tcs tires)
1/2 toe out front.
5mm front 5.5mm rear ride height.
High bite carpet,jack the gripper full front and rear