Hi all still trying to get to end speed out of my 21.5t speed passion V3 motor. Have tried a lot of setting and have found a little more speed but its getting hot (75c after 5 mins) but I want it to be lower temp wise and make it too 6mins.
My current setting are:
Motor timing 10 deg
FW 213
FDR 6.3
1 For/Brake
2 Drag Brake 0%
3 Voltage Prot 3.0v/cell
4 "DRRS" Punch Level 1
5 Brake Force 37.5%
6 Reverse Force 50%
7 Initial Brake 0%
8 Neutral Range 6%
9 Boost Timing 40
10 Turbo Slope 6
11 OverHeat Prot Enable
12 Turbo Timing 10
13 Start RPM 5000
14 Turbo Delay 0.3sec
15 Timing ACC 350
I have tried more and less boost and it didnt change the temp but more wasn't any quicker.
I tried going to 6000 on the turbo timing and it came in almost at the end of the straight. 4000 was quicker but temp after 3 mins and it was at 75c.
I tried the DRRS punch up higher, but it made the motor run hotter.
Where I am with the setting is only 4th's a lap off the fastest guys but I loose about 3 to 4 meters down the straight every lap. As its holding the car back with my driving is really good atm at worst my consistency is .1 to .2 in a run.
Should I gear it up?
The car (TOP Photon) has all new bearings and nothing is binding and is very free.
Any help would be great