Originally Posted by
jag88
okay, upon further review, it looks like the FR and RF front are the ones marked with the "plus x degree". So if I use a FR plus 1.0 degree with a FF 1.5 degree then I have a 1/2 degree pin sweep with a wider pin to pin dimension. This takes the place of the old method of using two 1.5s in the front (I'm guessing ?).
In this example would I have a 1/2 degree total, 1/4 on a side or 1/2 degree on each side ?
Thanks.
As far as I know, they are rated in additional degrees. Think of the normal FR and RF blocks as "0". using a +1 deg block will make it the same as a 1 deg toe block. They just don't require any grinding to install, which is pretty neato.
-Korey