Originally Posted by
j.d.roost
Hello.
I am mid build on my m05.
I am running the m05 ball diff and having a problem.
When using the stock dogbones the right side bone
binds up against the diff jamnut. If I dont run a dogbone "slider"
(the small black plastic c clip that connects to the diff side of the dogbone)
It wont hit but then the pins will float around in the diff.
Do I need to buy the cvd's to run the ball diff?
The diff spring was pre squished btw..
This can't be right,I have to be doing something wrong.
Please help.
JD you need to run the M03 universals with the M05 diff.
M05 Ball Diff Set
Hop-Up your M-05 with the Ball Differential Set. The differential set provides traction and stability to your machine even if one wheel has no contact with the track surface. This is a essential Hop-Up part for your M-05 chassis. *Not included in the M-05 PRO. Specs & Features Newly designed Aluminum Differential Joint A (Hard anodized) x 1pc. Newly designed Aluminum Differential Joint B (Hard anodized) x 1pc. 2x25mm Cap Screw x 1pc. 5x0.5mm Spacer x 1pc. 2mm Nylon Nut x 1pc. 3mm Steel Ball x 8pcs. Differential Plate x 2pcs. TRF414X Diff. Spring x 1pc. Urethane Bushing x 2pcs. 620 Reinforced Thrust Bearing x 1pc. 850 Bearing x 2pcs. 1510 Bearing x 2pcs. Ball Diff Grease 1g x 1pc. Diff Carrier x 1pc. TRF415MSX Y Parts (Swing Shaft Protector) x 1pc. Can be used with M-05 and M-05PRO kits. Note:
*Use with M03 Assembly Universal Shaft (Item 53597).
http://www3.towerhobbies.com/cgi-bin...?&I=LXETK4&P=Z
Speedtech has them for 24.99