Just to be sure I have understood: each shock cap must to be drilled with two holes of 1,2mm?(correct?)
But zero rebound is good only for very tight tracks with a very high grip or I can use zero rebound also outdoor on asphalt track with less than medium grip? I always knew that a percentage of rebound is good when the grip is not so high and/or track is a little bit bumpy? Am I right?
Rebound must be the same for all shock or is it possible to use different percentages of rebound between front and rear?
Thank you so much (!) in advance for clarifying it.
Ciao!
Originally Posted by
Hi-LowBlow
I almost always use zero rebound with two 1.2holes on top of the shock caps. When When you set some percentage of rebound on shocks, re-check them every couple of runs.