Hi all,
Been looking for more information about my F104 pro and I seem to have found it!
Been doing some research into converting my F104 pro to 1/10 pan car wheels, since I'm running a pan car as well this would make things easier.
Anyone done this? Any downfalls?
I figured for the front I can run 5mmx8mm flanged bearing to run the front wheels on the standard tamiya stub. I see Losi do a bearing for this.
What's the easiest way to convert the rear? I have done some searching and without doing some custom work I'm not sure how to do this. Can anyone shed some light on to this.
Sorry if this has been covered before, I have read through a few pages of this thread... but as you can see there's over 400 pages