Originally Posted by
PBLRDom
Ok sounds good, thanks for the advice.
Interesting. Wonder why they would put a sensor in that isn't accurate?
I think that the tune needs to be running a bit richer. Im going to take a look at that on my next outing. That might also explain why the truggy is running a bit hot.
How exactly do you adjust the idle speed on one of these guys?
I best bet would utube nitro engine needles to Lear them. The top end needle is the needle facing up on carb with the goldfish crown on it and bottom end is on throttle slide of carb, idle gfnerally is on carbs center stick out just slightly. A tuning tip is tune by hits like a clock onecfull turn is 24 hours. All it takes is a hour to make a large difference. Also a way to check tune is light throttle to mid on trigger is bottom end and half to full is top end. Look for a nice light stream of smoke from start to stop, generally if h have this with no high hanging idle once u go from high rpm to stop and no bogging.