R/C Tech Forums - View Single Post - The Speed Passion Thread
Thread: The Speed Passion Thread
View Single Post
Old 09-05-2011, 11:48 PM
  #7842  
sidecarphil1
Tech Master
iTrader: (1)
 
Join Date: Feb 2009
Posts: 1,920
Trader Rating: 1 (100%+)
Default
Originally Posted by hobbs
I have a silly question here.

Just got a new SP mmm V3.0 competition motor.
After looking up, down, front, back, left & right sides of the motor, I could not figure the way how to adjust the timing at the end bell.

Please advise.

Thanks
1st loosen the 3 screws on the front of the motor but not all the way , then tap LIGHTLY the pinion shaft then move the sensor connector to +20 or 11 depending what you want
sidecarphil1 is offline  
Reply