Originally Posted by
LOSI123
Thanks heaps guys, also is the optional white 20t centre pulley needed if upgrading from the standard Zero S spur holder/pulley, as the alum spur holder doesnt have a pulley on it as with the stock S one does.
Is there anything else i will need to run the alum spur holder on the Sakura S Zero, shaft the same etc?
Yes you need the pulleys. 20T is stock, 21 will tighten it up, 19 will loosen the belt a bit. Just remember that it will change the FDR for your calculations unless you use the stock 20T.
The spacers don't come in the Zero S. Not sure if other washer sizes would work. I am going to put them on today.
http://www.rcmart.com/catalog/rc-sak...=595_1419_1467
Pro10noob... Do you think its worth upgrading to the aluminum bulkheads on the ZeroS? Its the only hopup I have not done. Just not sure what it would help improve, other than looks.