So after some initial testing i am very happy with the new revtech motor. Dyno'd all my motors (RT,d1,d2 and d3) and out of the 2 revtech's I bought, one was a beast and the other is still better than my best d1 at 10 degrees timing.Ran both on the DYno with half a tick of timing and beast ran 0.9 amps, 20477 rpm at 2327 kv compared to the other @ 1.0/20224 and 2298kv. Started with conservative settings on the hobby wing(36/14) and my D3 gearing of 5.4fdr to be sure and was as quick as a mates fully tweaked d2 powered hw. Bumped up the settings to 42/18 and would have smoked the motor if i had not have pulled the run at 3 minutes @ 80c.
I will be testing more this weekend and will leave the HW settings at around 40 boost 14 turbo but will add more pinion and see how it handles that. Comparing the old motors to the new the D3 does like more gearing than the D1/2 so maybe the new RT will like even more gear. Hopefully my new 28c pack will arrive and i can really see what these motors will do with a fresh pack.
Last edited by Benzaah; 08-22-2011 at 01:22 AM.
Reason: speeling :)