Originally Posted by
Lazer Guy
With my GTP2e when I tried 8mm ride height.
The front bumper would hit the track off throttle, the bumper hangs down 4mm below the chassis, that leaves only 4mm front RH ????
The stock front springs and oil must be to soft ????
12mm from the bottom of the chassis (8mm from front bumper) is as low as I can go.
To get 4mm lower RH what should I change ????
The track I race on has some bumps and dips but not bad.
Thanks you.
SNR chassis uses the dm1 bumper so it's flush to the bottom,which give you more clearence, I went the cheap route and sanded the bottom my bumper to make it thinner-half the thickness- recounter sunk the screw holes and it's all good, you'll need a 90 degree counter sink to redo the holes, not 82,I'm gonna mod the bumper and put it under the front section of the front diff housing.