View Single Post
Old 08-01-2011, 10:34 PM  
jk1152
Tech Regular
 
jk1152's Avatar
 
Join Date: Jan 2008
Location: Houston, TX
Posts: 292
Default

Quote:
Originally Posted by Mark_Australia View Post
How are you cleaning them out? Removing the seal would wreck it right?
When I've done it. I take of the seal with an xacto knife. I the use an air compressor to blow out the grease. Then a little Nitro spray. Spin it a few times. Let it dry for a few minutes. Then use the grease of my choice. But heck I see most people just run them as the come, so I might not be so anal from now on and save some time.

I will still pack my grease of choice for the diff bulkhead bearings though on my Serpent S811.
jk1152 is offline   Reply With Quote